A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.

Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
Every technician is trained specifically on interior drain tile layout, slope, and tie-in to the sump system.
Interior drainage installs are scheduled locally, without routing through a national call center that adds weeks to the timeline.
Sump basin and pump costs are itemized separately so you can see exactly what makes up the total.
Drain tile that isn't sloped correctly simply won't move water — we verify slope with a level during installation, not just by eye.

We scope every Interior Drainage System job in person before quoting it, since two properties with the same symptom rarely need the same fix.
We route the full perimeter or targeted sections depending on where moisture is actually entering, based on the inspection.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
This option works well as a lower-disruption alternative to full perimeter drain tile in certain Troy, AL basement layouts.
We treat the cove joint as part of every interior drainage install, not as a separate add-on.
Existing drain tile that's clogged with silt or has failed slope can often be cleaned or repaired rather than fully replaced.

Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
We also check existing drainage, if any, to determine whether repair or new installation makes more sense.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
Most residential interior drainage installs finish in one to three days depending on perimeter length.

"Water was coming in along one wall every heavy rain. They installed targeted drain tile just on that section instead of charging us for the whole perimeter."
— Troy Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Troy Customer
"Explained the slope requirements in a way that actually made sense, not just technical jargon."
— Troy Homeowner
"Clean install, patched concrete matched the existing floor color almost perfectly."
— Troy Customer
Not always — if water is only entering along one wall, a targeted section can be enough, which we determine from inspection findings.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
Basin size is based on expected water inflow from the drain tile's linear footage and your Troy, AL area's typical rainfall intensity.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
We give you a realistic timeline in the written quote based on your specific basement layout.
We install and repair interior drainage systems throughout Troy and the surrounding Troy, AL service area, including the zip codes listed below.



Zip codes we serve in Troy, AL: 36079 36081 36082
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.